, and the pressure can be adjusted in the range of 8.82-22.05lbs, which are very convenient and conducive to making more beautiful and standardized items. The simple structure, convenient switches, practical pedal, clear pressure gauge and indication, and two models(manual and automatic) allow you to complete the installation and accurately control the amount of glue and free up your hands. The smooth surface allows you to easily remove dust and residues with a towel and water. With its good performance, this product can be used as a gift for family or friends engaged in manufacturing or operating relevant stores, making their work more efficient.The solid trapezoidal base can provide additional support to better maintain the stability of the product. This 6.56ft power cord. Allows you to have plenty of disposable lengths, thus reducing the limitation when you use it. The arc design can effectively prevent your skin from being scratched compared with the traditional square corners. This product can be widely used in manufacturing plants, workshops, construction sites, and stores for shoemaking (insole spray, sponge wrapping), toys (adhesive, fixation, insulation), box sealing, packaging, handbags, leather goods, leather bags, small household appliances, wires, hardware, small paper products, small ornaments, handicrafts, hairpins, electronic products, DIY design, and other manual or semi-automatic products that need glue. Confirm the safety protection measures. Check if the machine is 110VAC and make sure that the pressure will not fluctuate. See if the temperature of the plastic bucket is set at about.
Different hot melt adhesives have different softening points. For specific setting values, refer to the data provided by the hot melt adhesive supplier. Check whether the foot switch is connected and whether any conductive objects have touched the components in the electric control box.Check if the air supply system is basically dry and the air pressure is stable. Power on and test the circuit of each part. Connect the power and turn the power switch to "ON". Check if the temperature of the temperature controller is within the above range. Check whether the pressure relief is turned in the direction of pressure holding. Connect the origin, set the pressure value, and start the operation. Release the foot switch to cut off the main power. Disconnect the air pipe, or adjust the pressure regulating valve of the filter cup to 0. Sol Speed: 3kg/h, 6.61lbs/h. Solvent Capacity: 3kg/h, 6.61lbs/h. Length of Power Cord: About 2m/6.56ft. Please always wear safety gloves, goggles, and long-sleeved work clothes(not included) during use to avoid burning hot liquid hot melt adhesive. Before heating the melted glue, the pressure of the storage tank must be released first. After adding the sol, the lid of the glue tank must be locked. Please note that the gas circuit should avoid too much water vapor entering. The capacity of hot melt adhesive should not exceed one-seventh of the capacity of the storage tank. In order to achieve a better result and avoid damage, please set the minimum air pressure to 8.82lbs and the maximum temperature to 392? Please note that this product needs to be used with an air compressor, so you need to prepare it in advance. Please allow the slight color difference caused by the shooting light and 1-3cm error due to manual measurement, and make sure you do not mind before ordering. Feedback is very important to us.
It is impossible to address issues if we do not know about them! Faction is our ultimate goal. We work hard to earn your trust and future business. A If you receive a defective item, you may return it or ask for a discount.
Due to time zones, our reply to your questions may not be immediately. If it's non-workdays, please kindly be patient and wait till Monday. Creative Design, Durable Material, Beautiful Appearance. Easy installation, Convenient Use, Easy Operation.