Not hot, easy to use. Fit for PU V-belt, PU Pentagonal belt, PU round belt, PU tube, Plastic strips and other products can be easily melted.
The belt to be connected is fixed in the groove (usually V, O-groove) below the aluminum fixture (the clamp main refers to the gasket and nut). Specifically, remove the nuts on both sides of the nut and nuts (depending on the diameter of the belt, if the belt can be inserted directly into the groove, do not remove the nut and gasket), the belt into the groove, the gasket and Nuts re-fixed in the groove above the sides of the plywood in a parallel state, the spacing is about 2cm or so is appropriate (can be placed in the middle of the thermostat heater).
PU round with a small diameter of the polyurethane belt, please put the round belt on the top of the tank there, so that the round belt 2 connector alignment, then the larger diameter of the round belt or red polyurethane ribbons please put the bottom The inside of the groove! Will be heated to the constant temperature heater (the best temperature of the belt connection at 160-180 degrees), the fixed belt heating (the premise of the heat belt can not be bubbles, otherwise affect the connection effect), and then docking, the fixture Manual clamp nut tightened to the belt docking firm.
Belt docking to complete, to be completely cooled after the removal of the belt scraping, leveling. NOTE: The two ends of the belt must be cut flat, otherwise the connection is not good. 1 x PU Round Belt Welding Machine. We try our best to make sure every customer 100% satisfaction. Please verify your address when Pay it.It is not accepted to apply to modify the address after placing an order. If necessary, please cancel the order and place a new order. Shiped from California or New Jersey. (No service on Weekend and public holidays). Feedback is very important to us.
If you are not satisfied after receiving the product. Please do not leave negative review first. Customer Service Time (China Time).